Pool Repair in San Antonio.
Fixed Right the First Time.

Most residential pool pump repairs in San Antonio run between $150 and $500. On the lower end, you’re looking at fixes like a blown capacitor, a worn shaft seal, or a clogged impeller. On the higher end, you’re dealing with motor replacements or drive board failures on variable-speed pumps. A diagnostic visit identifies the specific failure point and quotes the repair before any work begins.

Yes. We service gas heaters, heat pumps, and electric heaters from all major brands. Common issues include failed ignitors, clogged burner assemblies, flow switch problems, and thermostat failures. Most heater repairs are completed in a single visit.

Most standard repairs are completed in one visit, typically 1 to 2 hours. More complex issues like leak detection, major plumbing work, or equipment that needs to be ordered may require a follow-up visit. We always communicate the timeline upfront.

Yes. Salt system repairs are a regular part of what we handle. The most common issues are calcium-scaled cells, flow sensor failures, control board malfunctions, and salinity calibration drift. We clean or replace cells as needed and recalibrate the system.

We prioritize equipment emergencies and typically respond within 24 to 48 hours. During peak season (May through September), scheduling is tighter, so calling as soon as you notice an issue helps us get to you faster.

If a repair costs more than 50% of a new unit, replacement usually makes more financial sense. We always provide a side-by-side comparison of repair cost versus replacement cost so you can make an informed decision. No pressure, just honest numbers.